Please use this identifier to cite or link to this item: http://hdl.handle.net/11455/34885
標題: Effective analysis of gaseous formaldehyde based on a platinum-deposited screen-printed edge band ultramicroelectrode coated with Nafion as solid polymer electrolyte
作者: Chou, C.H.
曾志明
Chang, J.L.
Zen, J.M.
關鍵字: Formaldehyde
Gas sensor
Square wave voltammetry
Screen-printed
electrode
Edge band ultramicroelectrode
acid fuel-cells
nio thin-film
formic-acid
gas sensor
electrocatalytic oxidation
sensitivity
fabrication
biosensor
phase
air
期刊/報告no:: Sensors and Actuators B-Chemical, Volume 147, Issue 2, Page(s) 669-675.
摘要: We report here the development of an electrochemical formaldehyde gas sensor based on a screen-printed edge band carbon ultramicroelectrode deposited with Pt nanoparticles and coated with Nation as the solid polymer electrolyte. The success of the proposed formaldehyde gas sensor lies not only in electrode itself but also in proper detecting scheme. In the detection scheme, a high potential was first applied to fully convert formaldehyde to formic acid and at the same time to release active sites of the Pt catalyst. On the cathodic scan, the overlap responses from the reduction of platinum oxide and the oxidation of formic acid were effectively differentiated by forward/reverse square wave voltammetry (SWV). Simply by measuring the current response of the reverse SWV, a linear calibration curve up to 5.1 ppm formaldehyde was obtained. For six continuous measurements of 0.3 ppm formaldehyde in the gas phase, a R.S.D. of 1.5% was obtained, indicating good reproducibility of the detection system. The detection limit was calculated as 80 ppb (S/N = 3). (C) 2010 Elsevier B.V. All rights reserved.
URI: http://hdl.handle.net/11455/34885
ISSN: 0925-4005
文章連結: http://dx.doi.org/10.1016/j.snb.2010.03.090
Appears in Collections:化學系所

文件中的檔案:

取得全文請前往華藝線上圖書館



Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.