Please use this identifier to cite or link to this item: http://hdl.handle.net/11455/44223
標題: An adaptive carrier synchronizer for M-QAM - Cable receiver
作者: Ke, C.N.
范志鵬
Huang, C.Y.
Fan, C.P.
關鍵字: Cable receiver
carrier recovery
QAM
synchronization
recovery
mode
期刊/報告no:: Ieee Transactions on Consumer Electronics, Volume 49, Issue 4, Page(s) 983-989.
摘要: A digital carrier recovery (CR) loop with an adaptive loop bandwidth for rapid carrier frequency offset acquisition and low steady-state jitter is proposed in this paper. In addition to the traditional CR functional blocks, the presented carrier synchronizer consists of a tracking-status detector and a loop bandwidth controller. The tracking-status detector monitors the frequency-estimate signals output from the frequency-tracking (integral) branch of the loop filter, detecting whether the frequency offset is locked or not. Then, by adjusting the loop bandwidth in response to the detected result, the convergence time of the acquisition-state and the carrier jitter in the steady-state can be reduced. The new scheme, implemented by FPGAs, has been successfully applied to a 256-QAM baseband digital receiver and also inter-operated with a commercial CMTS. The SNR performance can be improved up to 3 dB only at the expense of 3% hardware area of a Virtex-II-2000 FPGA for this proposed architecture.
URI: http://hdl.handle.net/11455/44223
ISSN: 0098-3063
Appears in Collections:電機工程學系所

文件中的檔案:

取得全文請前往華藝線上圖書館



Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.