Please use this identifier to cite or link to this item:
標題: Thermoelectric cooler application in electronic cooling
作者: Chein, R.
Huang, G.M.
關鍵字: thermoelectric cooler;electronic cooling;enforced regimes;microchannel heat sink;thermal management;performance
Project: Applied Thermal Engineering
期刊/報告no:: Applied Thermal Engineering, Volume 24, Issue 14-15, Page(s) 2207-2217.
This study addresses thermoelectric cooler (TEC) applications in the electronic cooling. The cold side temperature (T(c)) and temperature difference between TEC cold and hot sides (DeltaT=T(h)-T(c), T(h)=temperature of hot side of TEC) were used as the parameters. The cooling capacity, junction temperature, coefficient of performance (COP) of TEC and the required heat sink thermal resistance at the TEC hot side were computed. The results indicated that the cooling capacity could be increased as T(c) increased and DeltaT was reduced. The maximum cooling capacity and chip junction temperature obtained were 207 W and 88 degreesC, respectively. The required heat sink thermal resistance on TEC hot side was 0.054degreesC/W. Larger cooling capacity and higher COP could be obtained when the TEC was operated in the enforced regimes (DeltaT<0). However, TEC performance was restricted by the T(c) values and heat sink thermal resistance at the TEC hot side. A microchannel heat sink using water or air as the coolant was demonstrated to meet the low thermal heat sink resistance requirement for TEC operated at maximum cooling capacity conditions. (C) 2004 Elsevier Ltd. All rights reserved.
ISSN: 1359-4311
DOI: 10.1016/j.applthermaleng.2004.03.001
Appears in Collections:機械工程學系所

Show full item record

Google ScholarTM




Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.