Please use this identifier to cite or link to this item:
標題: NO removal by activated carbon-supported copper catalysts prepared by impregnation, polyol, and microwave heated polyol processes
作者: Chuang, K.H.
Lu, C.Y.
Wey, M.Y.
Huang, Y.N.
Project: Applied Catalysis a-General
期刊/報告no:: Applied Catalysis a-General, Volume 397, Issue 1-2, Page(s) 234-240.
The effect of HNO(3) pretreatment of activated carbon (AC)-supported copper catalysts for NO removal with NH(3) was studied. In addition, the effects of various preparation methods for Cu/AC catalysts, namely, impregnation (IM), polyol process (P), and microwave heated polyol process (MP), on the activity of NO removal with NH(3) were compared. HNO(3) pretreatment increased the number of carboxyl sites and promoted good dispersion of active sites. In addition, the chemical states of active phases were found to be affected when the catalysts were prepared by the microwave heated polyol process. More Cu(2)O particles were observed on the Cu/AC-N-MP catalyst than on the Cu/AC-N-P catalyst. The experimental results indicated that HNO(3) pretreatment of the AC support led to increased catalytic activity for NO removal with NH(3). The catalytic activity of the Cu/AC catalysts for NO removal at 200 degrees C decreased in the following order: Cu/AC-N-MP > Cu/AC-N-P > Cu/AC-N-IM. The microwave heated polyol process is a facile method for the rapid synthesis of carbon-supported Cu catalysts for NO removal at low temperature. (C) 2011 Elsevier B.V. All rights reserved.
ISSN: 0926-860X
DOI: 10.1016/j.apcata.2011.03.003
Appears in Collections:環境工程學系所

Show full item record

Google ScholarTM




Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.