Please use this identifier to cite or link to this item:
標題: The comparison between the polyol process and the impregnation method for the preparation of CNT-supported nanoscale Cu catalyst
作者: Lu, C.Y.
Tseng, H.H.
Wey, M.Y.
Hsueh, T.W.
關鍵字: Carbon nanotube;Catalyst;Polyol process;Impregnation;Oxidation;selective oxidation;carbon-monoxide;excess hydrogen;co oxidation;iron-oxide;removal;temperature;reduction;voc;no
Project: Chemical Engineering Journal
期刊/報告no:: Chemical Engineering Journal, Volume 145, Issue 3, Page(s) 461-467.
Carbon nanotubes (CNTs) are relatively potential materials for catalyst supports. CNT-supported Cu catalysts were prepared by an impregnation method and a polyol process. The catalytic activity was examined under different reaction atmospheres, Cu contents, and sizes of supports for CO oxidation. The experimental results showed that the active phase on the catalyst prepared by the impregnation method (10-20 nm) was smaller than that on the catalyst prepared by the polyol process (30-50 nm). Furthermore, the smaller active phase showed better performance for CO oxidation. Therefore, catalysts prepared by the impregnation method had a lower activation energy (57.47 kJ mol(-1)) than those prepared by the polyol process. The optimum CNT-supported Cu catalyst prepared by the impregnation method using 10-20 nm CNTs had a Cu content of 13.4 wt.%, and a CO conversion of 33% achieved at 125 degrees C with a total space velocity of 1.56 x 10(5) h(-1). (c) 2008 Elsevier B.V. All rights reserved.
ISSN: 1385-8947
DOI: 10.1016/j.cej.2008.04.033
Appears in Collections:環境工程學系所

Show full item record

Google ScholarTM




Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.