Please use this identifier to cite or link to this item: http://hdl.handle.net/11455/67634
標題: A study of ceramic addition in end termination of multilayer ceramics capacitors with cofiring process
作者: Lee, Y.C.
薛富盛
Lee, C.T.
Wang, S.
Shieu, F.S.
關鍵字: MLCC;end termination;dielectric properties;co-firing;microwave dielectric-properties;electrode;devices
Project: Materials Chemistry and Physics
期刊/報告no:: Materials Chemistry and Physics, Volume 100, Issue 2-3, Page(s) 355-360.
摘要: 
The silver paste with ceramics addition as end termination was performed on multilayer ceramic capacitors (MLCC) based on ZnO-B2O3 + Zn0.95Mg0.05TiO3 + 0.25TiO(2) ceramic (ZnBO-ZMT) with Ag95-PdO5 internal electrodes. A green sheet was prepared by tape casting using the ZnBO-ZMT' powders. Ag95-PdO5 was attached on the green sheet as an internal electrode. After lamination, the green chips were pre-sintered at 800 degrees C for 1 h, then samples were dipped the external electrodes and were cofired together at 900 degrees C for 2 h. There is no extra curing process, so the production cost may be cut down and thermal shock of the MLCCs may be reduced. To improve the mismatch between end termination and dielectric body during sintering, the silver paste with different amounts of ceramics, e.g., 20, 30 and 40 wt.%, was added in this study. The mechanical and electrical properties of the MLCCs were investigated subsequently. The results showed that end termination with 40 wt.% ceramic addition has good performances on mechanical properties of MLCC, but equivalent series resistance (ESR) is a little bit higher compared to end termination with 20 and 30 wt.% ceramic addition. (c) 2006 Elsevier B.V. All rights reserved.
URI: http://hdl.handle.net/11455/67634
ISSN: 0254-0584
DOI: 10.1016/j.matchemphys.2006.01.020
Appears in Collections:工學院

Show full item record
 

Google ScholarTM

Check

Altmetric

Altmetric


Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.