Please use this identifier to cite or link to this item: http://hdl.handle.net/11455/71472
標題: Design issues of two-dimensional amorphous silicon position-sensitive detectors
作者: Shung, J.Y.
Hsu, K.Y.J.
Jiang, Y.L.
Tsai, C.J.
關鍵字: amorphous silicon;position-sensitive detector;spectral response;uniformity;solar-cells;recombination
Project: Thin Solid Films
期刊/報告no:: Thin Solid Films, Volume 337, Issue 1-2, Page(s) 226-231.
摘要: 
The two-dimensional amorphous silicon position-sensitive detector (PSD) is usually in the form of large-area, continuous p-i-n silicon layer structure coupled with resistive layers next to the p and n Si layers. The device has many applications (e.g. light position measurements, light-pen input devices, etc.) and can be fabricated by using low-cost PECVD process. When used as a light-pen-based input device, several material-related design issues must be critically considered for achieving acceptable performance. The present work addresses three important issues, namely the spectral response of PSD, the uniformity requirement of the resistive layers, and the design of optical filter on the input side of PSD. They correspond to the signal-to-noise ratio of the device, the accuracy of light-position determination, and the integration problem with liquid crystal displays (LCD), respectively. Analytical analysis and computer simulation results draw the following important conclusions: (1) red-light-sensitive PSD can be obtained by properly tuning the thickness of p-layer and i-layer, which suppress the interference of background light when using the input device under sun light or similar illumination (2) the spot size of input light has little effect on position determination, as long as the size does not differ too much from that of required resolution. And a conservative uniformity requirement for the resistive layers can be obtained as \Delta h/h\ less than or equal to 4/n with n being the required number of pixels of display and h bring the film thickness (3) multi-layered filters made of oxides can be deposited on PSD to reflect non-signal light for LCD display while preserving the input-signal when the PSD is placed under a TN LCD. (C) 1999 Published by Elsevier Science S.A. All nights reserved.
URI: http://hdl.handle.net/11455/71472
ISSN: 0040-6090
DOI: 10.1016/s0040-6090(98)01382-0
Appears in Collections:期刊論文

Show full item record
 

Google ScholarTM

Check

Altmetric

Altmetric


Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.